Menu

andrew

Forum Replies Created

Viewing 1 replies (of 1 total)
  • Author
    Replies
  • in reply to: Video idea #885311
    andrewandrew
    Participant

      Hi Eric ,
      I remember seeing you do videos and have commented on too much rtv on gaskets and it being difficult to clean up and making a mess everywhere .
      I did a transmission service on my th700r4 transmission and found a way to hold the gasket in place without using any rtv or sealant at all.
      The way I did this was to use breadties .
      the pan gasket was placed on top of the pan and a breadtie inserted in all the 4 corners and twisted them to hold down the gasket in position.
      The pan is placed in position under the transmission and all the other bolts are started a couple of turns so that there is clearance to remove the breadties when you are ready to install the last 4 remaining bolts in the corners.
      if you think is a good idea then please make a video about it .
      andrew

    Viewing 1 replies (of 1 total)
    Loading…
    toto togel situs toto situs toto