[Wonkss]

ok went to wrecker and got a ignition coil for cyl 2/5 and replaced and misfire is gone. HooaH

[Wonkss]

ok went to wrecker and got a ignition coil for cyl 2/5 and replaced and misfire is gone. HooaH

[Wonkss]

ok went to part source got codes read since service engine soon light was flashing heres what he gave me and are they all related or?

p0302,p0403,p0405,p0443,p0449

[Wonkss]

ok went to part source got codes read since service engine soon light was flashing heres what he gave me and are they all related or?

p0302,p0403,p0405,p0443,p0449

[Wonkss]

would have to wait for it to be dark outside.im in Canada and no garage so its very cold and snowey 🙂

[Wonkss]

would have to wait for it to be dark outside.im in Canada and no garage so its very cold and snowey 🙂

[Wonkss]

well water did nothing for misfire.it did however make my service engine soon light flash which wasn’t even lit before.. I believe it started flashing when I cover the coil pack with water not completely sure as everything was pretty much soaked. any ideas..

[Wonkss]

well water did nothing for misfire.it did however make my service engine soon light flash which wasn’t even lit before.. I believe it started flashing when I cover the coil pack with water not completely sure as everything was pretty much soaked. any ideas..

[Wonkss]

would a vacuum leak only affect engine running while its operating temp?

like I mean one sec its fine then it starts missing temp gauge shows same spot. but its usually within it getting to that spot it starts missing. coolant level has not changed, oil is clean and fresh.

[Wonkss]

would a vacuum leak only affect engine running while its operating temp?

like I mean one sec its fine then it starts missing temp gauge shows same spot. but its usually within it getting to that spot it starts missing. coolant level has not changed, oil is clean and fresh.

[Wonkss]

I did the air filter and checked for vacuum leaks could not find any but only with feel and sound as im not sure I wanna use carb cleaner or something may start fire since it only does this when operating temp and not when cold.. I don’t have a gauge to check fuel pressure 🙂

[Wonkss]

I did the air filter and checked for vacuum leaks could not find any but only with feel and sound as im not sure I wanna use carb cleaner or something may start fire since it only does this when operating temp and not when cold.. I don’t have a gauge to check fuel pressure 🙂

[Wonkss]

turns out I had t pull my dash apart and remove the mpi immobilizer and now it works fine thanks for all that helped I eliminated the problem step by step till that and sure enough was a lot of hard work to remove it but it works now…

[Wonkss]

turns out I had t pull my dash apart and remove the mpi immobilizer and now it works fine thanks for all that helped I eliminated the problem step by step till that and sure enough was a lot of hard work to remove it but it works now…

[Wonkss]

the fused wire goes to the harness that came with the hid kit.. in the hid harness there is a box which I would think would hold a relay ( not sure though). Its he same harness Eric used to hook up his hid lights in his video. so I want to make sure I’m fine to use a wire from the passenger side headlight (which is not used right now ) and run it to a separate relay ill add to turn on the halogen Bright’s as well as letting the hid change to Bright’s as well.(hid headlights have hi/lo) so basically I would have hid and halogen Bright’s at the same time.but will not use the halogen while in low beam setting.

Thanks again for the help and replies

[Author]

Replies