Forum Replies Created
- AuthorReplies
Wait I tested the small ones, the big ones register continuity when the small ones have voltage
Attachments:Continuity test is a negative, it gives one short beep then silence. Also tried reversing the polarity
Attachments:Continuity test is a negative, it gives one short beep then silence. Also tried reversing the polarity
Attachments:Confirmed it clicks!
Also pic related testing setup lol
Confirmed it clicks!
Also pic related testing setup lol
Also pic related I pulled the one that said HEATER
Attachments:Also pic related I pulled the one that said HEATER
Attachments:Which pins breh, there are three small ones
Attachments:Which pins breh, there are three small ones
Attachments:For applying voltage would something like a 9volt work as the source?
For applying voltage would something like a 9volt work as the source?
I’ll have to wait till I get home to get the battery terminal off bastard is on there tight and I have no tools with me.
Fan is not always on when I just let it idle without the ac. Fact I’d say it mostly stays off then unless I let it sit long enough.
I’ll have to wait till I get home to get the battery terminal off bastard is on there tight and I have no tools with me.
Fan is not always on when I just let it idle without the ac. Fact I’d say it mostly stays off then unless I let it sit long enough.
OK, took it for a drive, got up to around 97 while at idle at a stop light, but went back down to mid 80s when I got back up to cruising speed (55)
Edit, I didn’t get a screen shot of it at the light but it was mid yo high 90s and said “closed loop, using o2 sensors for fuel mix” or something of that effect
Edit 2: not sure if its important but I did that with the ac off. I currently have it on as I type this and the hiccuping is much worse, engine says it’s in open loop and I’m at 85c
Attached picture for more info again.
OK, took it for a drive, got up to around 97 while at idle at a stop light, but went back down to mid 80s when I got back up to cruising speed (55)
Edit, I didn’t get a screen shot of it at the light but it was mid yo high 90s and said “closed loop, using o2 sensors for fuel mix” or something of that effect
Edit 2: not sure if its important but I did that with the ac off. I currently have it on as I type this and the hiccuping is much worse, engine says it’s in open loop and I’m at 85c
Attached picture for more info again.
- AuthorReplies