Forum Replies Created
-
AuthorReplies
-
Thanks for the tips. I’ll try them out and let you know.
It turned off when I turned the car off. I used the multimeter to check for a short from the battery. It read 0.58 then when I pulled the radio fuse it read a 0.08.
Sent from my GT-I9500 using Tapatalk
Okay…. do I put everything on the steering column back together and started it just to see what happens and the brake and parking lights work fine. No idea why or what I did. The only thing that happens now is when the radio turns on, the headlights turn off and vice versa. I pulled the radio fuse and everything seems fine for now. I’m just really confused with all the electrical issues what’s really causing it all and why is everything okay now besides the radio?
Sent from my GT-I9500 using Tapatalk
Okay… the front parking lights still come on when I press the brakes. I can hear clicking when I press the brake from what appears to be the relay. I pulled the CHMSEL relay and it turned the brake and parking lights off. I narrowed it down to that but now what do I look at from here? Thanks.
Sent from my GT-I9500 using Tapatalk
Okay… I’ll try it out tomorrow after work. I did mean the white reverse lights. Thanks.
Sent from my GT-I9500 using Tapatalk
Thanks for the video!! I got it to start and run. My problem now is that when I hit my brakes the reverse lights turn on in the rear and the parking lights turn on in the front of the truck. Also, the front head lights and constantly on, which they never did before.
I know it can be a bad ground some where, but where do I look? Since when I hit the brake, the lights are coming on in the front and back, where would I start looking for the possible issue? Also with the headlights? Are these two separate issues or just one? Thanks again!!
Yeah, it has the passlock. I’m trying to reset it leaving it in the On position for 10 minutes, then OFF for 5 seconds, then On again for the 3 times it says, but so far I haven’t been able to get it to stay on. I’m in the middle of trying it again right now. Not sure what else to do if this fails.
Thanks for the reply! Well I rechecked the fuses, relays and wiring. Pulled all the wiring from the battery to the grounds and everywhere else to look the over and clean them if necessary. Had to change a few ignition fuses again. Made some progress tho… it starts now, but immediately dies.
Thanks for all the replies. I’ll try your suggestions out and get back to you. Thanks.
Today I put the car in the air and put in drive. I heard the humming noise coming from the front drivers side. I seen the cv axle shaking a bit from the part closest to the transmission. Also, the passengers side wheel was not spinning at all until it got up to higher speeds.
Today I put the car in the air and put in drive. I heard the humming noise coming from the front drivers side. I seen the cv axle shaking a bit from the part closest to the transmission. Also, the passengers side wheel was not spinning at all until it got up to higher speeds.
Yeah, I’ve been noticing around the valve cover gaskets and intake manifold are showing a little bit of oil.
Yeah, I’ve been noticing around the valve cover gaskets and intake manifold are showing a little bit of oil.
Is there an easy way to accurately conclude that before I tear the vehicle apart? Thanks!
Is there an easy way to accurately conclude that before I tear the vehicle apart? Thanks!
-
AuthorReplies