Forum Replies Created
- Replies
The pic with the screwdriver is on the exhaust cam to help show the mark. How much room do u have with this can it be small fractions off?
The distink place where white pain is missing is the mark for the intake came. The crappy mark is the exhaust cam.
Hello I tested the 12v starter solenoid wire and had 12v. Found the problem to be the main ground which is attached to the tranny. It was very loose. O’Reillys took my starte back also so it was a 0$ fix.
Hello I tested the 12v starter solenoid wire and had 12v. Found the problem to be the main ground which is attached to the tranny. It was very loose. O’Reillys took my starte back also so it was a 0$ fix.
OK I definitely will need to check out connections at battery. I kind of doubt it’s the battery itself since its only 5 months old but you never know I’ll get it load tested.
OK I definitely will need to check out connections at battery. I kind of doubt it’s the battery itself since its only 5 months old but you never know I’ll get it load tested.
my EVAP canister is on top of the gas tank which i have removed from the car. There are not any obvious bolts holding it down just the rubber looking things that secure it to a mounting bracket. The canister is mounted to a mounting bracket that it on the gas tank. I have all the hoses off and everything, i just dont wanna break it trying to remove it. The only way to get the leak detection pump off on this vehicle is to first take of the canister. I did some research and i think it may be held on by a rubber push pin???
my EVAP canister is on top of the gas tank which i have removed from the car. There are not any obvious bolts holding it down just the rubber looking things that secure it to a mounting bracket. The canister is mounted to a mounting bracket that it on the gas tank. I have all the hoses off and everything, i just dont wanna break it trying to remove it. The only way to get the leak detection pump off on this vehicle is to first take of the canister. I did some research and i think it may be held on by a rubber push pin???
Hey sorry to not respond about the manufacturer info. I checked and I got this part new off of ebay for about 60 dollars, the manufacturer was not listed on the description.
Hey sorry to not respond about the manufacturer info. I checked and I got this part new off of ebay for about 60 dollars, the manufacturer was not listed on the description.
Hey all. Solution has been found. The cheap pump was wired incorrectly SSO pump ran backwards. Decided to get a pump from oreilies for a lot more money and it works! Also after replacing cracked evap lines my engine light is off so that’s nice. Thanks for the video Eric I will deff check it out.
