Forum Replies Created
- Replies
this happend to me recently — the bolt that attaches the bottom of the aftermarket pre-cat to the engine bracket botton would not line up once getting the exhaust manifold lined up and near tight. It connected fine to the rest of the exhaust pipe so I left it as is.
Is this going to break the car if i leave it that way? I’m only planning on keeping it another year.pre-cat that I bought: http://www.ebay.com/itm/252162071816?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT
——————————-
“Only to find out when I bolted up the rear heat shield (between the precat and engine) it held the exhaust flange that bolts to the motor at an angle to where it wouldnt seal ( 3/8” gap) so I had to “persuade” the supplied rear heat shield with a hammer.”