[Keith]

Did you ever find one? I looked up your part on RockAuto.com and shows a Dorman Part#674589. It does say Exc.California emmisions, but if you go to Autozone, they have the exact same part (Dorman 674589) and it says nothing about not for sale for California. I bought a set for my 97 Pathfinder from Rock Auto.com and all i had to do was remove the plug in the bung and install my O2 sensors.

[Keith]

Did you ever find one? I looked up your part on RockAuto.com and shows a Dorman Part#674589. It does say Exc.California emmisions, but if you go to Autozone, they have the exact same part (Dorman 674589) and it says nothing about not for sale for California. I bought a set for my 97 Pathfinder from Rock Auto.com and all i had to do was remove the plug in the bung and install my O2 sensors.

[Keith]

Motor mounts are done. Three of the four were torn. The fourth was a hydraulic type and once i pulled it i noticed all the dried hydraulic fluid under it. It feels like a brand new car now!!

[Keith]

Motor mounts are done. Three of the four were torn. The fourth was a hydraulic type and once i pulled it i noticed all the dried hydraulic fluid under it. It feels like a brand new car now!!

[Keith]

Done! Nothing a few beers and a three foot pry bar can’t fix!

Replace all four motor mounts next month

[Keith]

Done! Nothing a few beers and a three foot pry bar can’t fix!

Replace all four motor mounts next month

[Keith]

Good luck….sounds like you have a full plate. Post up any issues and solutions you ran into.

[Keith]

Good luck….sounds like you have a full plate. Post up any issues and solutions you ran into.

[Keith]

WOO HOO…got the axles out banana:
Since they’re out i’m replacing the swaybar/anti roll bar inner bushings…what a PITA!! I can’t get the two pieces to snap together!!! Not giving up…2 hours on one side already, but it’s only 1:45 and i have tomorrow off too

To Eric: If you ever get a 01-04 Volvo S40, i’d like to see you try the inner sway bar bushings!

[Keith]

WOO HOO…got the axles out banana:
Since they’re out i’m replacing the swaybar/anti roll bar inner bushings…what a PITA!! I can’t get the two pieces to snap together!!! Not giving up…2 hours on one side already, but it’s only 1:45 and i have tomorrow off too

To Eric: If you ever get a 01-04 Volvo S40, i’d like to see you try the inner sway bar bushings!

[Keith]

Thenks,
I’ll give it another try…i noticed the drivers side has the clip but the longe
r passenger side doesn’t. Hope i have the right parts. Guess i need to be careful not to mushroom the end in case in needs to go back in

[Keith]

Thenks,
I’ll give it another try…i noticed the drivers side has the clip but the longe
r passenger side doesn’t. Hope i have the right parts. Guess i need to be careful not to mushroom the end in case in needs to go back in

[Author]

Replies