Forum Replies Created
-
Replies
-
Okay, there’s a couple of other things you can check after the tires and wheel base (front to rear at center of hubs should be 2540mm or 100 inches). As earlier, measure the turning radius. Specs say 10.8m or 35.4ft in each direction.
This is a FWD auto, so check that the front sub-frame, if any, is square in the car.
A rough test for a square frame is to use pieces of string with a nut or bolt on one end tied to a spot on the front and diagonal rear, e.g. LF and RR corners, of the frame. Measure this distance, and compare that to the measurement of the same spots on the opposite corners. If they are the same, the frame is likely square. If the distances are different, double check the measurements by starting over. If still different, the frame MAY be bent. The only way to repair this is for a good shop to do it for you.