[Nathan N.]

Sorry it’s been so long for reply but discovered the problem. Someone replaced the fuel pump and between the pump and fuel line outlet was a short rubber hose with two clamps. Whoever tightened these clamps did not have hose pushed far enough onto pump, over time the hose split so it was sucking air if the fuel level dropped below about a half tank. Hope this helps someone.

[Nathan N.]

Sorry it’s been so long for reply but discovered the problem. Someone replaced the fuel pump and between the pump and fuel line outlet was a short rubber hose with two clamps. Whoever tightened these clamps did not have hose pushed far enough onto pump, over time the hose split so it was sucking air if the fuel level dropped below about a half tank. Hope this helps someone.

[Nathan N.]

Would you know where I can get a adapter for the fuel rail my scan tool won’t tell me fuel pressure and what is CoP ?

[Nathan N.]

Would you know where I can get a adapter for the fuel rail my scan tool won’t tell me fuel pressure and what is CoP ?

[Nathan N.]

I ran the codes it gave me system too lean bank one and two, misfire on start up, rand multiple misfires, cylinder 5 misfire and cylinder 6 misfire

[Nathan N.]

I ran the codes it gave me system too lean bank one and two, misfire on start up, rand multiple misfires, cylinder 5 misfire and cylinder 6 misfire

[Nathan N.]

I removed the switch and it moved freely so I applied a little grease and put it back. The lines were full of what looked like tranny fluid ? Any other thoughts? I want to try removing hubs and cleaning and greasing them. Do y’all think that would be a waste.

[Nathan N.]

I removed the switch and it moved freely so I applied a little grease and put it back. The lines were full of what looked like tranny fluid ? Any other thoughts? I want to try removing hubs and cleaning and greasing them. Do y’all think that would be a waste.

[Nathan N.]

Thanks guys I’ll check all that and report back.

[Nathan N.]

Thanks guys I’ll check all that and report back.

[Nathan N.]

Its a93 s10 blazer shift on fly. I replaced the 4×4 actuator because the old one had a rip in the rubber but the wheels still won’t kick in.

[Nathan N.]

Its a93 s10 blazer shift on fly. I replaced the 4×4 actuator because the old one had a rip in the rubber but the wheels still won’t kick in.

[Nathan N.]

Took it somewhere and they replaced the distributor n now it runs great. Thanks for the help guys.

[Nathan N.]

Took it somewhere and they replaced the distributor n now it runs great. Thanks for the help guys.

[Nathan N.]

I made a smoke machine and didn’t see any smoke coming anywhere. I will take it somewhere and post the fix. Thank you for the help.

[Author]

Replies