Forum Replies Created
-
Replies
-
Alright so i cleaned the throttle body and the IAC valve and it started up fine and i let it run for about 10 minutes. then about an hour later i went to start it and the same thing happened again, it really didn’t want to start then when it did, it stalled… and the only way to keep it running was by keeping my foot on the gas. i tryed tapping on the iac and the idle did not change. iv been reading around and from what i can tell it does not have a maf. what could be wrong with it please help!! the check engine light is not on and the idle when it does run is lower than it was before this all happened.
Alright so i cleaned the throttle body and the IAC valve and it started up fine and i let it run for about 10 minutes. then about an hour later i went to start it and the same thing happened again, it really didn’t want to start then when it did, it stalled… and the only way to keep it running was by keeping my foot on the gas. i tryed tapping on the iac and the idle did not change. iv been reading around and from what i can tell it does not have a maf. what could be wrong with it please help!! the check engine light is not on and the idle when it does run is lower than it was before this all happened.
I have a couple questions. what is the fitting on the end of the grease gun called and i cant find what type of grease a 99 jeep Cherokee 4wd would uses, or does it matter? if not what type of grease is normally used for this sorta thing.