Forum Replies Created
-
Replies
-
@hondaguy453 no mil, just driveability which, as you’ve guess, is my primary goal. I’ve been going through systems and every improvement I make is noticeable, but still not there yet. I’ll go into more detail:
found timing chain pretty darn sloppy. replaced.
found CMP Ret timing a couple pubes off. adjusted.Starts and runs fairly smooth with a slight miss here and there. But my biggest issue is when I punch it, it hesitates & I do hear a short burst of sucking sound. Not sure if it’s vacuum leak or throttle opening. But testing for vacuum leak with my vacuum gauge, I don’t believe. It runs pretty steady @ 18-19 PSI. And, even after reviewing vacuum diagnosis w/ Eric video, I believe she’s running normal. Fuel pressure to 60PSI and drops to 55 ish. Bleed down holds… but I’d say bleeds somewhere around 1/2 to 1 PSI per 60 seconds. So, I started looking through systems and am current @ EGR :]
yea gimme a couple days to get back under there. I got the tank out right now. I did find this yt vid with good closeups and a good understanding of the connection contraption… along with, well, It’s not my intention to plug a product, so if it’s not in good taste particularly from a new member I expect it’ll be censored.
thanx.
watch?v=6JhaHuib-WA
yuck I didn’t expect the full-link to add a yt plugin.
yea gimme a couple days to get back under there. I got the tank out right now. I did find this yt vid with good closeups and a good understanding of the connection contraption… along with, well, It’s not my intention to plug a product, so if it’s not in good taste particularly from a new member I expect it’ll be censored.
thanx.
watch?v=6JhaHuib-WA
yuck I didn’t expect the full-link to add a yt plugin.
Thanx… Some. I think that’s straight out of all data. Saw it once and fraq’n can’t even find it again. Even so, my main difficulty is visualizing the procedure. I don’t know what the images are but they don’t seem related, the ones I can make out anyway lol. I searched this quite a bit and didn’t even find that. No luck on yt yet. Might be time to design a special tool :]
Thanx… Some. I think that’s straight out of all data. Saw it once and fraq’n can’t even find it again. Even so, my main difficulty is visualizing the procedure. I don’t know what the images are but they don’t seem related, the ones I can make out anyway lol. I searched this quite a bit and didn’t even find that. No luck on yt yet. Might be time to design a special tool :]