[Erik Erikssen]

[quote=”Moose” post=20735]I’ve also been taught to never solder them. I’ve never really done the research as to why not to, but I was told that the sensor needs to draw fresh air from inbetween the wire strands to work properly, and the solder keeps it from drawing air. This was back in the day when one wire sensors were all you really encountered though, for what it’s worth.

It would be interesting to see if it makes a difference though.[/quote]
This is also my question

Bosch for Universal probe LHS24 say :

Video link for bosch with SmartLink thath can breath cable… :blink:

But NGK-NTK say :
http://www.ngksparkplugs.com/images/pdfs/universal_instruction_sheet_11-16-04.pdf
Fig. 3 Crimping and heating heat shrink tubing – butt-type connector – solder hole on

I can weld or not cable of my probe ? :S

[Author]

Replies