Forum Replies Created
-
Replies
-
Thanks Eric. I replaced the oil pan gasket with an oem one from the honda dealership and also used hondabond in the shaded areas according to the factory service manual. I unfortunately wasn’t able to put the exhaust back together yet due to bolts breaking and needing new studs for the exhaust manifold. At least the hondabond will have some time to cure fully though. The parts will be coming in the next few days so i can finish it up and add oil and check for leaks. Thanks again i will keep you updated.
The issue has been fixed. I flushed all of the old fluid out and replaced the pump. Filled it up with new honda fluid and bleed the system. The fluid is really clean with no bubbling or noise thankfully.
The issue has been fixed. I flushed all of the old fluid out and replaced the pump. Filled it up with new honda fluid and bleed the system. The fluid is really clean with no bubbling or noise thankfully.
I never changed the fluid. I just changed the o ring and then bleed the system. I checked all the lines and didn’t see any signs of a leak.
I never changed the fluid. I just changed the o ring and then bleed the system. I checked all the lines and didn’t see any signs of a leak.
yes when i replaced the o-ring and bleed the system the car is on jack stands with all 4 wheels off the ground.
yes when i replaced the o-ring and bleed the system the car is on jack stands with all 4 wheels off the ground.
yes i’m using the correct fluid, level is in between the 2 marks as required. I don’t see any kinked hoses and i’m not sure if there is a screen or filter.