[Ty]

Is it throwing any codes?

[Ty]

I suspect the wiper switch is at fault because if it were the linkage it wouldn’t work at all.

[Ty]

I seen this with engine cradle bushings before and the only ways around it are to grind off the head or cut it off.

[Ty]

With it loosing1 to 2 gallons a day there has got to be some signs of it dripping somewhere.

[Ty]

If the starter is falling apart then yes you need a new one.

Duct tape will not take the heat in that area it will just come off.

[Ty]

Now would be a good time to put on a new set of injector o-rings.

[Ty]

removed.

[Ty]

P0303 is a cylinder 3 misfire code.

Possible causes.
Faulty spark plug or wire Faulty coil (pack)
Faulty oxygen sensor(s)
Faulty fuel injector
Burned exhaust valve
Faulty catalytic converter(s)
Poor compression
Defective computer

[Ty]

Does the fan run at the same speed when its cold and when its hot?

The fan should run slower when cold then increase in speed when hot.

[Ty]

Maybe the coolant temp sensor is on the fritz.

[Ty]

If there the factory links they wont have zerk fitting and if the rattling around there done for.

[Ty]

+1 Stabilizer Bar Link or sway bar links there sometimes called are the most common rattling part on these cars.

[Ty]

Yes a map can be faulty without throwing a code so you could try a new one.

Also maybe the throttle position sensor.

[Ty]

+1 on the rotor shield contacting the rotor.

And whoever told you to spray WD 40 on your brakes needs to be beaten with a large stick that’s the last place to that you want oil on.

[Ty]

Im just going to say that the bulb is now degraded and needs to be replaced.

Normally the ballasts that drive them work or they don’t.

[Author]

Replies