[chughes]

Quoted From clearanceman:

Do I need a special tool to take the inner tie rod off?

You probably will, auto parts stores loan them out though.

http://www.autozone.com/autozone/access … l/_/N-264v

[chughes]

Put the hub back on the axle and tighten the nut up the drum will pull off of that might be rusted on pretty good so give it a couple taps with a hammer on the outside

Heres a video that should help you…

http://www.ehow.com/video_2327529_remov … -drum.html

[chughes]

Thank you guys I found out the problem, one of the cam sprockets must have slipped when I was putting on the belt. Re-timed it and it started right up!

Lesson learned.

[chughes]

Okay I checked it all about ten times and everything is hooked up correctly I checked the grounds on everything like the ignition coil, body, all the ground plugs, the engine head and block everything is grounded good. I charged the battery overnight so it’s got a good charge. I didn’t touch the crank sensor, but I checked and it is plugged in.

[chughes]

Okay I will double check that, but would that have anything to do with it not getting spark?

[Author]

Replies