Forum Replies Created
-
Replies
-
It’s a bottom bolt on the distributor. The other 2 are secure. Fired right up today and ran smooth as butter. Did have some exhaust fumes, probably because I reused the exhaust manifold gasket. Bled the cooling system with the spill free funnel (that I purchased because of one of your videos way back) and he (my son) has put about 50 miles on it with zero problem.
Service manual calls for 16° +/-2° for ignition timing and this one is at 10° according to my 30 yr old timing gun. I found the blue connector under the obd port behind a lower trim panel. I didn’t have time to remove the trim and couldn’t get the connector apart but I’ll try again Saturday.Question for Eric. Did you ever have a Honda with a stripped out adjuster bolt? Mine isn’t but I’m sure it’s happened. And did you apply any kind of lubricant to a new adjuster bolt?
Here is a better description (maybe). It’s almost like it’s a 1/2 tooth loose on the intake cam side. When I rotate the intake cam and go to the next groove on the belt then it’s too tight, and throws my timing off. As stated before another guy installed the belt in Jan and it was banjo string tight. Maybe it stretched a tiny bit? I’m tempted to just leave it be, but then my ocd wants to just replace it. Opinions are greatly appreciated.
It’s all back together but…. Haven’t started it yet. The timing belt concerns me. I tried your method from the video B timing belt and couldn’t get the front side of the belt “to stay tight”. It’ll be tight but then it will slack just a tad for just a second and go tight again. I have the engine all back together and have spun the engine many times by hand and tdc is always spot on. At this point I’m thinking of pulling the crank pulley and putting eyes on the tensioner to see if there’s anything going on. I’ve loosened and tightened the adjuster so many times I’m almost afraid to mess with it any more. Maybe I’m overthinking it?
I set the intake at .004 and exhaust at .007.Pretty much all that’s left is to torque the exhaust bolts, install air inlet, and adjust the valves. I followed Eric’s B timing belt video and that thing was still a bear. Maybe because it’s an aftermarket belt, but it took a lot of struggling to slide it over that intake Cam.
It’s on, and all timing marks are perfect. White TDC mark on crank is spot on and I can easily slide 2 drill bits through the top of the Cams. I took a pic but don’t know how to post it.
Thanks for those links Eric. Last time I lapped in new valves was in auto technology school 30+ yrs ago. If it happens again I’ll give it a go.Forgot to mention…this is the second burned exhaust valve in less than a year. My machine shop guy, that’s mostly does big V8 high HP engines recommended I bump up the valve adjustment from .004 & .007 to .007 & .010. The guy has been doing engines for decades but I’m unsure about whether I should do this.
*He was working on a cool 331 Hemi and a 454 punched to 497 when I walked in today.Thanks Eric! I’ve been watching your videos since the beginning. I’ve done Toyota’s and Subarus which all have the grenade pin tensioner but I’m not familiar with Honda. I’m going back with the head today so we’ll see. I purchased your B engine timing belt video and I’m going try to do as you did. Thanks again!