- This topic has 1 reply, 2 voices, and was last updated 7 years, 7 months ago by
.
-
Topic
-
I followed a link that was given to me to test my iat sensor. On the wiggle test I seen volt changing. So I cut the plug off. The Ecu still reads iat is 370 degrees. I went and did next test and checked for continuity. When I did that test the Ecu now gives me eld code, o2 heater sensor code, coolant temp sensor code and iat code. I think there is a short somewhere in the harness. Not sure why all the codes came up and all confirmed codes. There is no way all these sensors went bad at the same time. Not sure what the eld code is. Looked and it says electronic load. From what I could find it is the fuse box. Can someone explain some of this mess to me?
Thank you
Viewing 1 replies (of 1 total)
-
Replies
-
see if this helps.
Viewing 1 replies (of 1 total)
- You must be logged in to reply to this topic.