- This topic has 35 replies, 17 voices, and was last updated 10 years, 10 months ago by .
-
Topic
-
I have been a mechanic for a long time started back in 62 and have seen a lot of things change some good BUT mostly BAD
Stopped by a friends shop the other day. He had a 2010 Mazda sedan with a V6 with blown head gaskets
with 24,000 miles and the factory said it was NOT under warranty Well I found out that the engine was a Ford 3,0 V6
I am retired so I am Not in to it as much as I once was so I did not know that Mazda came with fords engines
Now I will say there is NO way to get the heads off with the engine in the car ALso there is NO way to replace the water pump with out removing the engine Ended up removing the whole engine trans cradle and lifting the car up on the lift
Found the heads are warped because of a water pump failure
I just hate to think of some poor tech on flat rate doing this job He would get totally F%^^% on this job I am told this is the same engine thats in the ford edge My point is if you would have told me that you have to remove an engine just to replace a water pump I would have thought you were NUTs And to the engineer that designed that engine he should be FRIED
http://img.photobucket.com/albums/v511/stingray66/IMG_0731_zpsdba5d63c.jpg?t=1358284133
http://img.photobucket.com/albums/v511/stingray66/IMG_0730_zpsfa852d35.jpg?t=1358284211
- You must be logged in to reply to this topic.