- This topic has 7 replies, 2 voices, and was last updated 7 years, 11 months ago by .
-
Topic
-
Good evening,
It has been a while since I was last here I have been busy Getting elected to the NH state house and going to work for New York Life. I have however not finished working on my project truck the 1996 Dodge Ram 1500 5.2L, the current project is the K&N Air Intake 57-1511-2, I have it it appears installed, mostly, the intake tube is having trouble fitting over the throttle body and screw down stud is offset from center. I may have a little pirate air coming in from behind back side of the throttle body.
Does anyone have any advice on how I might resolve this issue. I spoke with K&N this afternoon who believe that the Throttle body on the 2nd Gens built in Mexico are different from the Throttle bodies on US built Rams.
I could use advice, there is very little clearance and I have short arms so reaching the back of the engine bay is difficult at best. If anyone is the Southern NH area and can come out and give me a hand I wouldn’t mind that either.
Thank you
- You must be logged in to reply to this topic.