- This topic has 7 replies, 5 voices, and was last updated 11 years ago by
.
-
Topic
-
metro ,spray penetrating oil and hope the hell there not locked up if they are cut off ,going to have to put o rings and new bolts and muffler ,want to cut off old one and clamp on new one looked at videos on youtube ,have not found ETCG video,need to tighten up the hole exhaust and fix up over time ,
-
Replies
-
A lot of times, even if the bolts are pretty frozen up, using a torch, and heating them up good will get them lose. I often combine the heat from a propane torch (not necessarily hot enough to get the job done on it’s own) with a good dousing of non flammable Liquid Wrench. The two together are quite helpful. An impact gun will also make things go much easier.
[quote=”Tomh” post=82867]A lot of times, even if the bolts are pretty frozen up, using a torch, and heating them up good will get them lose. I often combine the heat from a propane torch (not necessarily hot enough to get the job done on it’s own) with a good dousing of non flammable Liquid Wrench. The two together are quite helpful. An impact gun will also make things go much easier.[/quote]
Try the MAPP substitute (real MAPP gas is gone, turns out the plant was in pretty shitty condition and they found it cheaper to shutdown than fix the problems)
It burns hottest and has more BTUs than Propane.
- You must be logged in to reply to this topic.