Menu

setting timing advance with light dial

Home Forums Stay Dirty Lounge Service and Repair Questions Answered Here setting timing advance with light dial

  • Creator
    Topic
  • #491205
    DonnieDonnie
    Participant

      hi im getting ready to fire up my new crate engine and every things getting dialed i just need to know what my advanced timming should be on a 5.9 dodge 360 gas stock engine for my slt larrame 1500 THANK YOU . :side: :silly: :whistle:

    Viewing 7 replies - 16 through 22 (of 22 total)
    • Author
      Replies
    • #491920
      sam priemsam priem
      Participant

        the drbIII is the dealership scan tool specific for the 90’s/early 2000’s dodge vehicles. its a handheld tool and is portable but the dealership wont let it leave the shop. the other tool that i know for a fact has the ability is the OTC genisys 5.0. awesome tool and very common (mac and matco also make the same tool its just a different name but i believe all 3 are supported by SPX)

        #491926
        DonnieDonnie
        Participant

          hey SAM every thing went awsome went through all my steps no leaks in rails nor any where else fired up and ran smooth and did 16 miniutes at 1800 rpms ran like a champ to morrow high performance shop will set distributer 110.00 not a bad savings on the hole procedure. THANKS TO YOU YOUR MY HERO BRO THANK YOU FOR EVERYTHING AND ERIC FOR SHURE and thanks colledge man AND YES IT ALL HELPED!!!!!!!!!!YOUR AWSOME !!!! THANK YOU!!!SAM ill be in touch thanks…

          #491929
          sam priemsam priem
          Participant

            thanks for the update. glad to hear everything worked out for you. good luck with the new engine.

            #492122
            DonnieDonnie
            Participant

              hi sam or any one i have a question regarding the metal diafram that the oil filter screws onto switched over to new Engine seemed pretty tight coming off is there a spec for going back on or do i just make it tight tight gasket is on and lube in oil? is that correct and is there a torque spec for going on?????????

              #492204
              sam priemsam priem
              Participant

                just wrap a shop rag around it, lube the ring with oil and get it nice and snug by hand. the gasket will do the rest.

                #492383
                DonnieDonnie
                Participant

                  AWSOME THANKS SAM!!!!!!!!

                  #493651
                  EricTheCarGuy 1EricTheCarGuy
                  Keymaster

                    Honestly I couldn’t have been much help on this one but I’m glad you got everything all worked out. Well done forum!

                  Viewing 7 replies - 16 through 22 (of 22 total)
                  • You must be logged in to reply to this topic.
                  Loading…
                  toto slot toto togel situs toto situs toto https://www.kimiafarmabali.com/
                  situs toto situs toto