- This topic has 4 replies, 4 voices, and was last updated 13 years ago by
.
-
Topic
-
-
Replies
-
The honda special tool is probably a paperclip shrouded in plastic for only $49.99. I’ll build you one for only $29.99 🙂
wondering if anyone knows where to source the female 2 pin connector. I have wiring looms from several hondas and have yet to find the female side of the connector anywhere to rob.
07PAZ-001010A.
I bought one from Handaaccessories.com…….It works for SRS air bag and I just tried this on my 91 accord service connector it works. Genuine honda jumper cable. You guys should check it out.
Beefy,
What a kind and generous individual you are. What a deal! C:P I have been looking for some swamp land in Florida. Can you hook me up?
Dancoig,
As a suggestion try your local Radio Shack. They will not have the connector that Eric made, but they show them the service port and they will come up with something that does the job quick and easy. When I had a fuel gauge on an old jeep (very hard to find NOS parts), I did not know a resistor from a capacitor. When I told the guy I need to increase the resistance in a dead wire by a certain ohm level, it took him about 5 minutes to set me up with a few penny parts to solder together. Job done!
As for me, I will stick with the thin gauge hobby wire. I might go fancy and put a flat blade male connector on it someday. Paper clips have not worked so well for me.
- You must be logged in to reply to this topic.