Replacement of Pilot Rear Bumper – Welded Nut

This topic has 6 replies, 1 voice, and was last updated 9 months, 1 week ago by orabelle hana.

Creator

Topic
October 25, 2021 at 5:57 am #992780
Keith Kachelhofer
Participant
I like the idea of spot welding the nut to the frame however, could a rivet nut been used instead? This was a perfect application for the use of a rivet nut provided the material was not too thick.

Thoughts?
Creator

Topic

Viewing 6 replies - 1 through 6 (of 6 total)

Author

Replies
October 25, 2021 at 6:19 am #992781
EricTheCarGuy
Keymaster
Possibly, but keep in mind the size was 10x 1.25. Also, the ‘frame’ is pretty thick in that area. It might not work.
September 29, 2023 at 9:45 am #1026364
Francisco Taylor
Participant
It’s important to consider the specific requirements of your application, including the material thickness, load-bearing capacity, and environmental conditions.
October 5, 2023 at 4:56 am #1026520
Antonio Giles
Participant
Rivet nuts can often be just as strong/secure as spot welding, provided the rivet nut is properly set into the material. drift hunters
November 13, 2023 at 10:04 pm #1027432
eva willms
Participant
It might work. Run 3
December 3, 2023 at 9:33 pm #1028125
fakal fesela
Participant
The ‘frame’ is pretty thick in that drift boss area
- This reply was modified 1 year ago by fakal fesela.
March 22, 2024 at 4:00 am #1030588
orabelle hana
Participant
maybe grade calculator
Author

Replies

Viewing 6 replies - 1 through 6 (of 6 total)

You must be logged in to reply to this topic.

Loading…

toto slot toto togel situs toto situs toto https://www.kimiafarmabali.com/

situs toto situs toto