Menu

Oil problems (i think)

  • Creator
    Topic
  • #488449
    Michael PMichael P
    Participant

      So I took off my bro-in-law’s oil cap and noticed that the underside of it a gooey-like yellow color….is that a bad thing??

    Viewing 6 replies - 16 through 21 (of 21 total)
    • Author
      Replies
    • #500074
      college mancollege man
      Moderator

        if the line from the valve cover goes to the manifold
        that would be vacuum.It should have a PCV somewhere in that
        line.

        #500076
        SkipSkip
        Participant

          should i change the PCV if it is in the line or just remove the whole line and blow it out with carb cleaner? Thanks again.

          #500218
          college mancollege man
          Moderator

            clean the line.But replace the PCV.

            #502325
            EricTheCarGuy 1EricTheCarGuy
            Keymaster

              Glad you got it sorted out. Condensation would be an issue with a vehicle that only gets driven for short trips. Try to drive it more in the future and it should cut down on the problem.

              #502341
              SkipSkip
              Participant

                Actually, I have not done anything about this issue yet. I the formed line mentioned previously that comes out of the top of valve cover on oil cap side, is very thin diameter like 1/4 inch and is only about 18 inches long. It runs into a bigger rubber hose and so far I have not found a PCV on the line so I am not sure how to proceed to clean the line out. I removed oil cap again and found more cream on it even though I just wiped it off a short time ago. The formed small diameter line enters the valve cover thru a rubber boot – do I just pull it out of that boot? Not sure how to get it off so that I can run carb cleaner thru it to clear it out. Appeciate your help – you videos on youtube are awesome!

                #504900
                EricTheCarGuy 1EricTheCarGuy
                Keymaster

                  A picture would be helpful. I think if you just got the engine nice and hot it should clear out. You may not have to do any removing to do the cleaning.

                Viewing 6 replies - 16 through 21 (of 21 total)
                • You must be logged in to reply to this topic.
                Loading…