- This topic has 4 replies, 5 voices, and was last updated 11 years, 9 months ago by
.
-
Topic
-
Okay so all of today went to trying to get this flywheel off, its pressed in from factory and we spent all day using different pulling methods and its stuck!! we even pulled the ring gear off on accident, heated it up, beat it, pryed it, this was all after trying to use the bolt holes that were ment to remove it, also the puller tool wont work
-
Replies
-
set up your puller, and have an impact wrench handy. hold dry ice (frozen CO2) on flat area around shaft (USE HEAVY INSULATED GLOVES!! or you’ll get frostbite.) for several minutes to shrink center of flywheel. then hit the center puller bolt with the impact. that should pop it off.
when you go to put the new one on, use dry ice again to make the center of the flywheel shrink. work quickly and the new one should go right on.
good luck, and let us know what works out for you.
Moparfan7008
see if this helps. as suggested an impact gun. You also may have to
cherry the fly wheel when trying to remove.My question is why remove it? If you’re just replacing the clutch you can just clean the flywheel up with sand paper or a roloc disc and you should be just fine. I’ve done it for years with no issues.
- You must be logged in to reply to this topic.