Menu

Long Engine Support Bar needed

Home Forums Stay Dirty Lounge Tool Talk Long Engine Support Bar needed

  • Creator
    Topic
  • #467366
    ssd16ssd16
    Participant

      Hi All,

      I need to do a rear main seal on a 2003 Honda Pilot. I need an engine support bar that will do 63″, but am having trouble finding one long enough. Does anyone know of a product that would suit?

      Thanks.

    Viewing 2 replies - 1 through 2 (of 2 total)
    • Author
      Replies
    • #467372
      619DioFan619DioFan
      Participant

        most only reach to 57” you can make one. get a piece of 2″ x 4″ square tube ( .120 wall ) and cut to the right length. add some legs to each end , couple lengths of chain to hold the motor ( you could probably even use some good quality ratchet straps ) probably cost about 50 bucks.

        #469415
        ssd16ssd16
        Participant

          Found one, OTC 1725 3 Point Engine Support Bar. 68″ maximum width.

          Thanks

        Viewing 2 replies - 1 through 2 (of 2 total)
        • You must be logged in to reply to this topic.
        Loading…
        toto slot toto togel situs toto situs toto https://www.kimiafarmabali.com/
        situs toto situs toto