How to upgrade incandescent bulb to LED light

[Mathieu]

Some knowledge to know about upgrading the the incandescent light over bulb light.
The LED start to light up with a specific amount of volt and amp. Incandescent light light up at any volt and amp with less or more light. CREE LED are the brigtess LED available on the market of the lumen per square inch.

LED online shop for the socket size for your car brand

Tail braking light upgrade
-The tail light should have a led that support 2 different voltage to allow to have light when you start up your head light and a brighter intensity when you puch the brake pedal. You can choose a LED that have a lower volt resistance to do the same thing in the car socket.

Turn signal LED upgrade
-The head and tail turn light must have a wire modification on each bulb replacement to be allow to have the same original flash signal speed. You need to use a altimeter to know the amount of volt and amp that have been lose after the electricity past in the incandescent bulb. That way,you compare the resistance with the same equipment with LED in place. You calculate the gap of volt between the to resistor (bulb old and LED bulb). At the end, you do this : AMPERES x OHMS = VOLTS A flow of charge produces a voltage it encounters resistance (Equation reference)). You should be able to choose a right amount of Ohm resistance in the negative wire beside the bulb to mimic the incandescent bulb.

Rear signal and other LED light inside the car
-The LED can fit in his specific socket for his locations.

Topic