How difficult is it to replace the oil pan gasket?

[Juan Reyes]

I own a 1996 Ford Taurus it has the 3.0 V6 DOHC Duratec engine. A mechanic told me I have an oil leak and I have to replace the oil pan gasket on it. I have never done this before. I am just wondering how difficult is it to replace? I called around and every shop said including the dealership said 2.2 hours. I got a range of prices too starting at $275 and ending at $370 dollars.

I just want to do this myself to save money. I own a small mechanics tool set from Home Depot I got years ago. I don’t own a torque wrench though. Do I need one for this job? I also own car ramps and wheel chocks.

I had a mobil car mechanic come and replace the oil pressure sender a while ago. I saw the oil leaks myself and that’s why I took it for a quick checkup to a mechanic. He saw the oil pressure sender and then told me about the oil pan gasket.

Should I have a professional do this or can I do this myself? I like working on my own car and I like saving my money. I already have replaced brake pads, rotors, spark plugs and spark plug wires.

What should I do?

Topic

[college man]

see if this helps.

http://answers.yahoo.com/question/index?qid=20070310073120AAWjkVE

[Jeff Ketchem]

I have done one and to be honest it wasn’t hard, but I had a lift and my arsenal handy. I don’t know how agreeable I’d be to doing it on jackstands or ramps though. lol

[asetoftools]

depends on the car really. Take a look at the manual. If you can see all the bolts, and dont have to remove anything like a motor mount, then It should be pretty easy. Both my oil pan and transmission pan drop right out of my car with like 20 bolts each or something. So in my case, its one of the easier things I have done, on jackstands even.

I would get a haynes manual or chiltons before you do anything.

from college man link, looks like you gotta remove exhaust 🙁 I wouldnt do that myself unless its not rusted. Most exhaust stuff is much easier with an impact and heat i gather.

and from this, ( https://www.google.com/search?tbm=isch&q=corsica%20oil%20pan&tbs=imgo:1#q=Ford+Taurus+oil+pan&tbm=isch&tbs=imgo:1 ) it looks like a deep pan. On my car its very shallow. Its probably worth the service, unless you got the time and want to put in the elbow grease to “Remove Y-pipe and catalytic converter assembly.”. That looks like the hardest for a street mechanic to me. Unless its all brand new. my 2 cents

[EricTheCarGuy]

I believe the link that College man posted is accurate and is a good step by step for the job. I would be careful using ramps though. Those can be difficult sometimes but once you’re up on them you’re supported pretty good. Sometimes they do get in the way while you’re working however but for that job it shouldn’t be too bad. Personally, I prefer to use a jack and jack stands. As for the torque wrench, I don’t think you need it. As long as you’re consistent and don’t over tighten. One way to do this is by using 1/4″ tools to do the work. They have less leverage and less of a tendency to brake fasteners or over tighten. That’s not to say that using a torque wrench is not a good idea. Also, don’t go overboard with RTV. This is a common rookie mistake. It really doesn’t help seal and in some cases can actually cause leaks. Let the gasket do the work and only use RTV at the seams or corners in small amounts. If you ever have to take the pan off again, you’ll thank me.

Good luck and keep us posted how the job goes.

[Author]

Replies