Higher compression on one cylinder = Higher oil consumption

[NiCoXis]

Well, as we car guys know time in our world pass at a different pace that normal people. We finally began building the engine today! here are some pictures of the process_x000D_
_x000D_
The block was bored then re-skirted to go back to standard spec (86mm)_x000D_

Topic

[EricTheCarGuy]

http://www.youtube.com/watch?v=tBD-rFP7q9c

[NiCoXis]

These are some pictures to show how much do valves lift when the bigger camshaft lobes are used_x000D_
_x000D_
Exhaust valves,_x000D_
_x000D_
Low rpm lobes,_x000D_
_x000D_
_x000D_
High rpm lobes,_x000D_
_x000D_
_x000D_
_x000D_
Intake valves,_x000D_

[NiCoXis]

And these is some additional things I’m using on this setup,_x000D_
_x000D_
Apexi S-AFC 2_x000D_
_x000D_
_x000D_
This allows corrections to the AFR under a certain throttle load and RPM range. It also monitors detonation, max RPMs, etc._x000D_
_x000D_
Wideba

[EricTheCarGuy]

I pray the car gods smile on you.

[NiCoXis]

Victory! 😀 [url=http://www.youtube.com/watch?v=ktZGXmW4dJo:3i733kbm]_x000D_
_x000D_
First start_x000D_
http://www.youtube.com/watch?v=ktZGXmW4dJo_x000D_
_x000D_
M[/url]easuring compression :O_x000D_
[url=http://www.youtube.com/watch?v=Jd7nTGjcp5o:3i733kbm]http://www.youtube.com/watch?v=Jd7nTGjcp5o_x000D_
_x000D_
S[/url]

[dreamer2355]

Awesome job!_x000D_
_x000D_
As for the gage, i am not familiar with tool companies in your area so i cant recommend anything, sorry 🙁

[NiCoXis]

Quoted From dreamer2355:_x000D_
_x000D_
Awesome job!_x000D_
_x000D_
As for the gage, i am not familiar with tool companies in your area so i cant recommend anything, sorry 🙁

_x000D_
_x000D_
Thanks!_x000D_
_x000D_
I usually import everything so it doesn’t matter if it’s overseas._x000D_

[EricTheCarGuy]

After watching video 3 I think you’re good.

[Author]

Replies