- This topic has 4 replies, 2 voices, and was last updated 8 years, 9 months ago by
.
-
Topic
-
-
Replies
-
Question about valve adjustment in your video honda element. When you rotate and align piston 1 you adjusted the intake first top dead center on base circle. What about the exhaust is it also on top dead center at the same time? I know its easy but Im confuse when you rotate the engine. Because on the video you just keep inserting the feeler gauge. I dont know if EACH valve intake or exhaust should be on the top dead center. But when you rotate the engine on intake is on top dead center? Please elaborate clearly? Thank you. Am I going to rotate the engine 8 times of 4 times only?
ON the number one cylinder both intake and exhaust will be adjusting the clearance at the same time. So, no need to rotate the engine?
[quote=”neiskyle3″ post=164662]ON the number one cylinder both intake and exhaust will be adjusting the clearance at the same time. So, no need to rotate the engine?[/quote]
If You have questions as the above Please start a thread in service and repair.
This section is for new member introduction. 🙂
- You must be logged in to reply to this topic.