heater core remova

[Jose Morales]

I haved a leak of antifreeze inside my 2000 jeep grand cherokee lardo. I removed the entire dashboard and encounter a new problem… I don’t know how to remove the hvac unit out from the car. I don’t see any fastener that attached it to car body.

can some one help me out with this, and guide me on how to take the hvac unit out of the car…

thanks for the help!!!!

Topic

[Lord Ihcalam]

did you check the engine compartment for bolts that go through the fire wall?

[josh]

I agree, it is most likely bolted through the fire wall

[college man]

[quote=”jmorales1982″ post=42846]I haved a leak of antifreeze inside my 2000 jeep grand cherokee lardo. I removed the entire dashboard and encounter a new problem… I don’t know how to remove the hvac unit out from the car. I don’t see any fastener that attached it to car body.

can some one help me out with this, and guide me on how to take the hvac unit out of the car…

thanks for the help!!!![/quote]

I posted over at your original post.Please don’t start new posts for
the same vehicle problem.It gets confusing. 😳

[Jose Morales]

🙂 thank you for the help guys!!!
so following up with the core leak, I fanally took the core out and replace it, then I put everithing back together where it goes. but now the truck has no ingnition power, I check the connections to see if I forgot to plug one up but all looks fine, check my fuse box for a bad fuse they all good. I can find what is causing the power issue. can I get some checkup poins ideas please…. :unsure:

[spelunkerd]

When you did the repair did you remove the neg battery cable before working under the dash? I wonder if there may be a security system problem. When you turn the key, do the dash lights turn on? If it’s a security problem, there is often a clue from warning messages on the dash or maybe diagnostic codes…. Failing all of that, I would retrace your steps.

[Jose Morales]

no, there is no light on my dash boad when i turn the key, but everything works but the ignition and the redio

[Jose Morales]

and yes, I remove the negative cable from the battery, when I started the work.

[Jose Morales]

I would like to thanks each and every one that help me fix the issue with my jeep…
I fanally got it fix and running. 🙂 so thank you all for helpping me do the job and save me some money…

[college man]

Your welcome.But what caused the no start and what fixed it?

[Jose Morales]

After dismantle the dashboard ones again I find the source of the power issue. I have forgotten to tide up a scrude that secure one of the main connection on the passager side.

[college man]

Thanks for the update and the fix. 🙂

[EricTheCarGuy]

Sounds like you forgot to hook up a ground. Thanks for the update and for using the ETCG forum.

[Author]

Replies