Menu

COOLANT INFORMATION / POWER STEERING ISSUE

Home Forums Stay Dirty Lounge Service and Repair Questions Answered Here COOLANT INFORMATION / POWER STEERING ISSUE

  • Creator
    Topic
  • #469543
    drthrift035drthrift035
    Participant

      FORD E-250 GASOLINE ENGINE 5.2 L

      99,970 KM

      1) ENGINE TEMPERATURE GAUGE IS IN THE NORMAL OPERATING RANGE.

      2) COOLANT TESTING READING 45 F/ 43 C FOR FREEZING POINT

      3) BOILING POINT 265 – 269 F

      WHAT IS THE BEST WAY TO TEST ENGINE COOLANT STRENGTH AND WHAT IT IT’S ACCEPTABLE RANGE FOR FREEZING CAPACITY AND HEATING CAPACITY.

      POWER STEERING SYSTEM

      NOISE FROM THE POWER STEERING SYSTEM

      CHECKED POWER STEERING RESERVOIR – LOW FLUID LEVEL

      SEARCHED FOR LEAKS. NO LEAKS FOUND IN C0NTAINER OR HOSE

      ADDED MORE POWER STEERING FLUID AND CIRCULATED IT IN THE SYSTEM BY TURNING THE WHEELS FROM LEFT TO RIGHT.

      [b]NOISE WENT AWAY. WHAT IS THE MOST EFFECTIVE WAY TO DIAGNOSE THE POWER STEERING

      SYSTEM [/b] THANKS IN ADVANCE.

    Viewing 6 replies - 1 through 6 (of 6 total)
    • Author
      Replies
    • #469674
      EricTheCarGuy 1EricTheCarGuy
      Keymaster

        A hydrometer is often used to check coolant but it sounds like you already have one of those unless I’m mistaken as to how you got your numbers. If you’re concerned you can always do a drain and refill with fresh coolant to ensure the best protection. Most times a 50/50 mix is recommended but if you’re in a colder climate you may need more antifreeze for better protection in colder temps.

        If you don’t see a power steering leak then perhaps the rack is leaking behind the rack boots. Pull the boots back or poke a small hole in them to see if fluid comes out, if it does the rack is leaking internally. I’d recommend replacement rather than trying to repair the seals.

        #469712
        college mancollege man
        Moderator

          A+ on Erics post.

          #469718
          dreamer2355dreamer2355
          Participant

            I agree with Eric also.

            We use test strips at work for testing a coolants protection level, reserve alkalinity and pH level.

            #469755
            CharlesCharles
            Participant

              One word of caution. I lived in Alaska for a couple of years. Pure antifreeze will freeze (makes slush that will not circulate). So some minimum amount of water is required. Best to go by the instructions on the container.

              #469917
              drthrift035drthrift035
              Participant

                Thanks for the advice. I did the coolant flush and it was no problem. I made sure that I followed the bleeding process.

                I am going to check into the rack to see if there is any internal leakage. Thanks again.

                #469991
                EricTheCarGuy 1EricTheCarGuy
                Keymaster

                  If you’re in a climate similar to Alaska then I would suggest you consider a block heater as the poster is correct antifreeze will only protect so much to a given temperature.

                Viewing 6 replies - 1 through 6 (of 6 total)
                • You must be logged in to reply to this topic.
                Loading…
                toto togel situs toto situs toto