Menu

Compliance bushing.

Home › Forums › Stay Dirty Lounge › Service and Repair Questions Answered Here › Compliance bushing.

  • Creator
    Topic
  • June 3, 2013 at 3:23 am #527094
    THERMALTHERMAL
    Participant

      What is the correct position to install bushings in the lower control arm ? Bushing marked with 2 white dots. Arm marker with one white dot. Are these the alignment marks? Pictures attached.

      Attachments:
    • Creator
      Topic
    Viewing 3 replies - 1 through 3 (of 3 total)
    • Author
      Replies
    • June 3, 2013 at 6:13 am #527109
      fitonefitone
      Participant

        Your old bushings will have the two arrows on them where the two white marks are located 180 degree apart on your new bushings. The other two marks on your new bushings should be installed in the same location as your old bushings. All of this is easier to see after the LCA has been removed. Just mark all of these points prior to pressing out the old bushings and install the new ones to match old locations.

        June 3, 2013 at 7:21 am #527148
        THERMALTHERMAL
        Participant

          What if the old bushing was previously install in a wrong position? How else would I know what is the true alignment of a new bushing.

          June 4, 2013 at 4:18 am #527412
          fitonefitone
          Participant

            Based on your photo the old bushing on that side is installed correctly.

          • Author
            Replies
          Viewing 3 replies - 1 through 3 (of 3 total)
          • You must be logged in to reply to this topic.
          Loading…