Menu

’98 GMC 1500 – Intermittent Rough Running

Home Forums Stay Dirty Lounge Service and Repair Questions Answered Here ’98 GMC 1500 – Intermittent Rough Running

  • Creator
    Topic
  • #543909
    ThomasThomas
    Participant

      So my truck is a ’98 GMC 1500, 2wd, 4.3 Vortec V6, 348,000 km, auto trans.
      90% of the time, the truck runs great, except for what I believe is an unrelated issue, I’ll explain in a minute.
      So once or twice a week, the truck won’t idle, and start hesitating, overall just running crappy. It seems to be mainly at the lower rpms, seems to clear around 3000 rpm. It usually lasts until it ends up stalling from the low idle which is usually pretty quick if I don’t notice it. It normally starts back up hard like it’s flooded, pedal to the floor helps. Once it starts tho and I give it a couple good revs, it runs just fine. That’s also without turning the key to off the off position. Check engine light came on once with a map sensor code.
      So what I’ve done so far:
      New map sensor, cleaned egr valve and made sure it wasn’t sticking, and cleaned the throttle body including the idle circuit.

    Viewing 3 replies - 31 through 33 (of 33 total)
    • Author
      Replies
    • #548477
      ThomasThomas
      Participant

        So I put my new fuel pump in today, and the truck runs perfect now. When I get on the gas hard it’ll downshift, rev, and accelerate, instead of studdering and slowing down.
        I also believe I found the root of the problem with the evap system, when the pump last got replaced, the return and evap lines got switched, causing the evap to draw fuel from the bottom of the tank.

        So now is the first time I’ve been able to hammer on the gas of this truck since I bought it, and it’s got tons of power for a V6, great for pulling away from f-150’s and ram’s hehe

        #548485
        college mancollege man
        Moderator

          Glad you worked it out.Thanks for the update and the fix. 🙂

          #548511
          Chris cagnoChris cagno
          Participant

            Nice glad u worked it out thank for the update

          Viewing 3 replies - 31 through 33 (of 33 total)
          • You must be logged in to reply to this topic.
          Loading…