Menu

91′ Accord Crank Pulley Bolt Removal

Home › Forums › Stay Dirty Lounge › Service and Repair Questions Answered Here › 91′ Accord Crank Pulley Bolt Removal

  • Creator
    Topic
  • October 15, 2012 at 7:14 am #469009
    curtie94curtie94
    Participant

      Ok so I’ve tried about everything. It is a 5-speed so its in gear and won’t turn freely. I have tried a impact with 600 ft/lb of of reverse torque and nothing. are there any ideas on how to do this.

    • Creator
      Topic
    Viewing 3 replies - 1 through 3 (of 3 total)
    • Author
      Replies
    • October 15, 2012 at 9:30 am #469021
      Sang Kimskim3544
      Participant

        Buy a special tool. 600 ft/lb isn’t enough for this bolt. I have seen this bolt came out with impact wrench only once and the mechanic was using 1″ impact wrench. So unless you have access to something stronger, you can forget about trying to get this off using a impact wrench. If you have access to acetylene torch you can try heating the mounting surface to red hot then hit it with impact. Otherwise only way to pull this out is using a special tool + 18 – 25 inch breaker bar.

        October 15, 2012 at 9:59 am #469034
        MikhailMikhail
        Participant

          Strange. I used a 240 ft lb electric impact gun and it did the job well. But I think you need to use the special tool.

          October 16, 2012 at 9:58 pm #469410
          EricTheCarGuy 1EricTheCarGuy
          Keymaster

            They do get on there pretty good sometimes, the special tool and a breaker bar with a pipe is the way to go in my opinion. I haven’t had one beat me yet with that method.

          • Author
            Replies
          Viewing 3 replies - 1 through 3 (of 3 total)
          • You must be logged in to reply to this topic.
          Loading…