- This topic has 0 replies, 1 voice, and was last updated 12 years, 7 months ago by
.
-
Topic
-
I have 2 words for you on the crank sensor, “aftermarket distributor”. The crank sensor is located in the distributor on that model and if an aftermarket distributor is installed getting crank sensor codes is quite common.
The OBDII connector is actually located on the RIGHT side of the dash just to the left under the glovebox, it can be hard to find for those not familiar with it’s location.
It’s quite common for that model to have ABS sensors go bad in the rear but be mindful because if you find the bad one the bolts for the lower strut mounts tend to seize in the bushings making it impossible to take them out without cutting them and replacing the bushing or lower control arm. I believe you check for those codes by removing the inspection cover just above the right lower back seat, it’s a small square piece of plastic you can pop off and when you turn the key to the ON position you will see a red LED flash the ABS code.
- You must be logged in to reply to this topic.