2001 Ford Focus ZX3 ignition cylinder

This topic has 7 replies, 3 voices, and was last updated 8 years, 3 months ago by Jake.

Creator

Topic
September 5, 2016 at 8:06 pm #867356
jean Horsley
Participant
I am trying to get the ignition cylinder out to replace it. The tiny hole that you put a screw driver in to push the release button on cylinder..do i just need something to push it in ?
Creator

Topic

Viewing 7 replies - 1 through 7 (of 7 total)

Author

Replies
September 5, 2016 at 8:23 pm #867361
Jake
Participant
Yes. And the key in the accessory or ignition position, I don’t remember which.
September 5, 2016 at 8:25 pm #867362
Richard Kirshy
Participant
See if this helps:
September 5, 2016 at 9:46 pm #867370
jean Horsley
Participant
Ty guys. It has to be in accessories position. Now new question is..when i shake the ignition cylinder should i hear shaking sound feom inside?
September 5, 2016 at 10:00 pm #867371
Richard Kirshy
Participant
Might try looking down the key slot..
Could be the tumblers floating around.
September 5, 2016 at 10:40 pm #867374
jean Horsley
Participant
If i buy a lock/cylinder with 2 keys from autozone do i still need a professional to program the keys? My car does have that black plastic sensor around cylinder. ..
September 5, 2016 at 11:01 pm #867379
Richard Kirshy
Participant
Not familiar with your specific setup.
Some require the ignition switch replaced with new keys, some may require reprogramming
Some models can have the mechanical tumbler section rebuilt and continue to use the original keys.
Suggest you inquire at the dealership the best way to proceed.
September 6, 2016 at 12:49 pm #867432
Jake
Participant
Yes, the keys will have to be programmed for the PATS.
Author

Replies

Viewing 7 replies - 1 through 7 (of 7 total)

You must be logged in to reply to this topic.

Loading…

toto togel situs toto situs toto