- This topic has 2 replies, 2 voices, and was last updated 12 years, 11 months ago by
.
-
Topic
-
Viewing 2 replies - 1 through 2 (of 2 total)
-
Replies
-
Did you use a suitable grease to relube any metal to metal contact points on the braking system as well as the guide pins?
Is any of the brake hardware rubbing against the rotors or even the splash shield?
Did you change the pads too and did you put the pads back from the same side you took them off?
Any un-even pad surface wear?
Thanks for the tip. I raised the vehicle at the front end, blocked all the rear wheels,set the emergency brake and put the car in drive. I then inspected the wheels at both front ends. I couldn’t hear any noise. I couldn’t see anything rubbing together either. So I’m gonna chalk it up to tire noise.
Viewing 2 replies - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.