- This topic has 3 replies, 4 voices, and was last updated 8 years, 3 months ago by
.
-
Topic
-
-
Replies
-
Most of the time, fairly new fail gasket, usually is cause, by improper installation, not torque properly.
[quote=”cdt456″ post=175913]Most of the time, fairly new fail gasket, usually is cause, by improper installation, not torque properly.[/quote]
Absolutely true i have replaced them before still finding bits of the old gasket under the new ones and once where someone had used tape to hold them in place when the intake manifold was installed that was my favorite lol.
[quote=”Disabled Automotive” post=175916][quote=”cdt456″ post=175913]Most of the time, fairly new fail gasket, usually is cause, by improper installation, not torque properly.[/quote]
Absolutely true i have replaced them before still finding bits of the old gasket under the new ones and once where someone had used tape to hold them in place when the intake manifold was installed that was my favorite lol.[/quote]
Tape? That must have been good for more than a few laughs.x3 on the other comments
Surface preparation, proper amount of torque and correct torqueing sequence are absolutely essential.
- You must be logged in to reply to this topic.