- This topic has 14 replies, 6 voices, and was last updated 12 years, 4 months ago by
.
-
Topic
-
-
Replies
-
[quote]Quoted From lnknprkfn312@hotmail.com: _x000D_
_x000D_
added to one would have to wonder if it was a replacement axle did the old one come off with the c-clip intact(as unlikely as it may be)? or maybe just try to fee/look around inside for anything thatThe axle im using is the same axle I disconnected when I started the clutch replacement. And I wouldnt install the axle without the c clip lol and leave it in there. But um I mentioned that I took off the c clip and plugged the axle back without it to rul
[b]Be carefull and dont do any hard turn to right or left. Without c clip it can go out from transaxle.
added to one would have to wonder if it was a replacement axle did the old one come off with the c-clip intact(as unlikely as it may be)? or maybe just try to fee/look around inside for anything that might be stopping it?
I would never leave the axle in place with out the c clip!!!!!!! Im not stupid guyssss…….. I put the c clip back on……. becuz there was no difference without it except that it locks when the c clip is on. But as of right now the c clip is on the ax
Alright guys here is a picture of the drivers side axle im talking about. Keep in mind that I took off the seal and put it on the axle then inserted the axle so im not sure if the seal is all the way in
THanx for the replies guys. As of right now i am having some isues with a proper clutch adjustment which I had made another post. Trying to turn the pushrod from the master cylinder to a point were I can press in the slave cylinder by hand which ultimatel
- You must be logged in to reply to this topic.