- This topic has 4 replies, 2 voices, and was last updated 7 years, 1 month ago by
.
-
Topic
-
(Skip to paragraph 2 to start hearing issuesI’m working on a 79 Bronco that has sat for a while (since 01) but I am in the process of getting her back on the streets again, the truck is to the stage of running and driving, now the lighting and I’ll be on my way.
I have no brake lights or rear hazards, however the blinkers both ways are functioning fine. I have been test probing this truck for 3 days straight trying to locate this issue. I know I have power to the brake switch and it is functioning as intended. I know the hazard switch seems to be functioning as well as the flasher for it, however just the fronts blink. I am at a loss. Any input with be greatly appreciated
Thanks
~Ryan
-
Replies
-
Just a thought…
I see you have a trailer setup.
Might inspect the trailer harness and connection(s) on the vehicle for corrosion and / or damage.I usually agree here but truck is what they call a “Trailer special”, it’s a factory installed harness, I’ll still check it out though
FOUND THE ISSUE, the blinker switch had gotten internally hot enough to melt the plastic around a peice of spring steel that was used to make the contacts and lose connection
Thanks for the help though!
~Ryan
- You must be logged in to reply to this topic.