Quick and Dirty Search2
This is the Video page search.  Type in a topic or title to find the video you want to watch.


User Rating: 5 / 5

Star ActiveStar ActiveStar ActiveStar ActiveStar Active

Here is the sequel to the Nissan Altima Intake Gasket Replacement video.

This all started with the Nissan Misfire Diagnosis video. In that video I found that the intake gasket on this 2.4L Nissan was leaking at cylinder #4. It's been a difficult job so far but I think we have it licked.

Star InactiveStar InactiveStar InactiveStar InactiveStar Inactive

In a way this is a sequel to the Nissan Altima Misfire Diagnosis Video. It would have been a REALLY long video if I posted both together. In fact I had to split this video into 2 parts as it is. This job isn't for the weak at heart. It took me most of the day to get it done.

User Rating: 5 / 5

Star ActiveStar ActiveStar ActiveStar ActiveStar Active

It's actually quite common for these radiators to fail this way so if you own a Honda of this vintage I'm sure you'll have to replace a radiator at some point. As the title says if it's an Acura 2.3 CL or an Accord this procedure will work as they are both pretty much the same vehicle. Also as pointed out in the video probably the most critical part is to make sure you bleed the air out of the system properly.

User Rating: 5 / 5

Star ActiveStar ActiveStar ActiveStar ActiveStar Active

Here we have the dramatic conclusion of the Tahoe 5.7L water pump replacement series. There are some important steps here that need to be followed in order to call this job done. Bleeding the cooling system is at the top of that list. As I said in the video I feel this is a job that's well within the reach of the DIY. So break out the spanners and get to work.

User Rating: 5 / 5

Star ActiveStar ActiveStar ActiveStar ActiveStar Active

This video is part 1 of the replacement of a water pump on a 5.7L Chevy V8. This video will apply to many other makes that use this engine such as GMC as the engine in this video has been used for many years by GM. I feel it's a job that just about any DIY could do with the right set of tools.